I am seeing this pop up in work that is being posted here so here's a bit of friendly advice. When you are working with MENCS 19 templates, you have to keep in mind that the sides of the templates are not straight across, they are titled a little. So, to get your logos and such to look good you need to tilt them a little bit. What you do is find your angle tool wherever that is, and with your just pasted and resized logo selected, do the following.
On the driver side, you put the angle at -1 and this will get your logo tilted the right way. Then once the logo is where you want it, duplicate and move to the passenger side and roughly locate it. Transform 180 to get it flipped. Back to angle tool. This time you use 2 and your logo will be tilted right. Then its on to final positioning and presto you have your logos the way they should be and ready to finish the rest of your wonderful creation.
Hope this helps,
White Eagle
On the driver side, you put the angle at -1 and this will get your logo tilted the right way. Then once the logo is where you want it, duplicate and move to the passenger side and roughly locate it. Transform 180 to get it flipped. Back to angle tool. This time you use 2 and your logo will be tilted right. Then its on to final positioning and presto you have your logos the way they should be and ready to finish the rest of your wonderful creation.
Hope this helps,
White Eagle