Just a couple things I have been noticing as I have painted for MENCS....Rear wheel logo placement....First of all, pay close attention to the upper curve of the wheelwell mask...Keep your logo inside the mask so all of it will show up...I have made that mistake and when I go to create the car, the bottom of the logo is chopped off...If that's the way you want it, ok, but for those who want the entire logo showing, keep the mask wireframe lines in mind.
Secondly, when you have the logo positioned and sized the way you want, to make it look the best, you need to enable transition box and look for the bottom line of the rear wheel as well as the top wireframe line of where the body curves in to the rear window area. Keep those two lines in mind and then tilt your logo to line up generally with them. That will help your logo show up right when you go to finalize the car in NR2003.
Just a couple things I have noticed!
Happy painting!
White Eagle
Secondly, when you have the logo positioned and sized the way you want, to make it look the best, you need to enable transition box and look for the bottom line of the rear wheel as well as the top wireframe line of where the body curves in to the rear window area. Keep those two lines in mind and then tilt your logo to line up generally with them. That will help your logo show up right when you go to finalize the car in NR2003.
Just a couple things I have noticed!
Happy painting!
White Eagle